Tag: mouldings
-
Ural Starter Truck – Part Two – Straight Into It
And likely to remain straight, as well. The designers of this Ural kit are smarter than the average bear. The moulded the basic frame as one piece with springs attached and a number of extremely precise location holes throughout it. This meant that, even in the hurley burley of a club morning – with the…
-
CAC Wirraway – Part Four – Gappy vs Gapless
It is pretty simple to guess whether kit builders prefer their models with good or bad fit. But if there is going to be a situation in between – where do you want the gaps to fall? The aircraft modeller generally sees it in wings and tail, with the ambitious factories inventing new places to…
-
Dornier Do-17Z – Part Three – So Near…
And yet so far… I was really hoping to get the Dornier 17Z buttoned up with no need for filler as a tribute to the old Monogram moulders. Such was not to be the case, but in the meantime I am puzzling over the inside of the wing. The Monogram engravings are there alright, as…
-
Dewoitine D- 510 – Part Two – I Underestimated Them
I should not have been so cynical about the KP moulders. The wings of the Dewoitine D-510 looked a little unsure at the start – the tabs seemed vestigial. The fitting surfaces minimal. I foresaw structural re-enforcement needed. I was wrong. The kit fits. The cockpit goes into the fuselage without trimming – the fuselage…
-
RCAF Avro Lancaster – Part Three – It All Starts With Bits
I try to be thrilled with all parts of the kit building I do – from the shopping and acquisition through to the plans, cutting and fitting, painting , and final assembly. But it must be said that there are times when the stages are very small and you don’t seem to progress. The initial…
The Little World 